Download RX Debug - Renesas Electronics

CubeSuite+ V1.01.00
APPENDIX A WINDOW REFERENCE
[Printf event] tab
This tab is used to configure Printf events as action events (see "2.16.1 Insert printf").
A Printf event momentarily stops the execution of the program at a specified location, and executes the printf command
via software processing. When a Printf event is set, the program momentarily stops immediately before executing the
command at the location where this event is set, and the value of the variable expression specified in this dialog box is
output to the Output panel.
Figure A-43. Action Events Dialog Box: [Printf Event] Tab
(1)
(2)
(3)
[Function buttons]
This section describes the following.
- [How to open]
- [Description of each area]
- [Function buttons]
[How to open]
- On the Editor panel, move the caret to the line where you wish to set a Printf event, then select [Register Action
Event...] from the context menu.
- On the Disassemble panel, move the caret to the address where you wish to set a Printf event, then select
[Register Action Event...] from the context menu.
- On the Events panel, select [Edit the conditions...] from the context menu after selecting the Printf event.
[Description of each area]
(1) [Output string] area
Type in the string to add to the Output panel directly via the keyboard (up to 1024 characters).
R20UT0769EJ0100 Rev.1.00
Oct 01, 2011
Page 330 of 429