User’s Manual
Your unit features:
 High quality crystalline solar panel
 Water proof design provides longer life in all weather conditions
 Automatic sensor turns the light on at dusk
 4 Ultra bright LED’s
Location of the SOLAR PANEL
1) For optimal results, place the solar panel in a position where it can get direct
sunlight and will be generally free from cover and shade.
2) Make sure that the photo sensor near the solar cell is not going to be affected
by any other light source. If there is a light source cast over the photo sensor
during the evening the floodlights will
not illuminate.
3) The solar panel must be left to
charge for 2 sunny days before best
results are achieved.
Assembly Instructions
1) Carefully remove the solar lamp and all the fittings out of the box.
2) Assemble the mounting poles and stake for the solar panel. Push the stake
directly into the ground (DO NOT hammer). Slot the head on the mounting
pole carefully.
3) Screw the lamp heads to the base stakes.
4) Allow to charge for two fully sunny days before using the floodlights
5) Adjust the switch on the underside of the solar panel to the “AUTO” position.
Operation Instructions
1) For daily / normal operation, turn the switch to the “AUTO” position. It will
automatically turn on during the night time.
2) The performance of the solar garden light system will vary with the time of
year. It will release more light when it has had a full day in the sun rather than
a day in overcast weather.
Replacing the Batteries
For best results rechargeable Ni-Cd batteries should be replaced every 12
1) Unscrew the 3 screws on the front of the unit.
2) Remove the old batteries. Make sure to replace with rechargeable batteries of
the same type and size. Install the new batteries in to the battery
compartment, ensuring the correct polarity is observed.
3) Reassemble the unit.
Trouble Shooting
If your solar flood light does not come on at dusk despite observance of all
the instructions, please try the following steps:
1) Make sure that the SOLAR PANEL is not being affected by any other light
2) Ensure the SOLAR PANEL is not shaded during the day.
3) Make sure the switch is in the auto position.
4) Check that the batteries are installed correctly.
Clean the solar module regularly with a damp towel to guarantee optimum
performance of the solar panel. Do not use any type of solvent for cleaning and
be careful not to put too much pressure on the module while cleaning.
Limited Warranty
This product is covered by a one year limited warranty. Sunforce Products Inc
warrants to the original purchaser that this product is free from defects in
materials and workmanship for the period of one year from date of purchase.
This warranty does not apply in the event of misuse or abuse of the product or as
a result of unauthorized repairs or alterations.
To obtain warranty service please contact Sunforce Products for further
instruction, at 1-888-478-6435 or email [email protected]. Proof of
purchase including date, and an explanation of complaint is required for warranty
For more information or technical support
[email protected]