Download FXE2000-G User`s Manual

6. Maintenance
Restoring the Software Settings
The software settings of this product can be recovered by using the saved setup file.
Using FTP to Restore the Settings
Follow the procedure below to recover the software settings using FTP.
(1) Move to the folder with file.
(2) Run FTP to log in to the AP.
(3) Transfer the settings file(config).
MACFLIST is also transferred if necessary.
(4) Issue the reset request command(command :
quote crst).
(5) Quit FTP.
The following is an example for the time when Windows Command Prompt (MS-DOS Prompt) is used.
In this example, the file will be moved to the folder with file D : ¥tmp and CONFIG and MACFLIST will
be transferred after connecting to the product via FTP. The example assumes the IP address as
192.168.0.1.
C:¥>cd D:¥tmp
………… (1)
D:¥tmp>ftp 192.168.0.1
………… (2)
ftp>put CONFIG
………… (3)
ftp>put MACFLIST
………… (3)
ftp>quote rst
………… (4)
ftp>bye
………… (5)
The reset request command shown in (4) is a command used to reboot the product.
to skip (4), stop FTP in (5) and reboot the product later.
66
There is no problem
FXE2000-G