Download 3 shape - Wieland Dental

Transcript
Hint! Move the points out of undercut areas, since undercuts at the margin line may result in a bad fit.
Therefore, visualize the automatically extracted points in order to check if one or more points are in the undercut area.
The individual points can be moved either manually or using the Step button. When the Step button is pressed, the points on
the spline can be moved using the keyboard:


Press the RIGHT and LEFT arrow keys on the keyboard to change between the points (each point is displayed as a
green ball placed on a red line) on the individual die.
Press the UP and DOWN arrow keys on the keyboard to move the points up and down
If a point needs to be moved a long distance and faster, press Ctrl + UP/DOWN or Shift + UP/DOWN.
When the points are moved using keyboard, the 2D Margin line window appears for a precise positioning of the individual
points in the margin line.
When the Step button is not pressed, you can move points with the mouse by clicking and dragging them. Right-click on a
point and choose Remove to delete individual points and choose Add to create new points.
It is always possible to get a new estimate of the margin line by pressing the Recalc. button and to clear the spline by
pressing the Clear button.
The Point distance box defines the distance between each point on the automatically extracted spline.
The Angle is the angular difference between the margin direction (see description below) and the angle used in the “red
pencil” margin line algorithm.
The Maintain angle slide bar defines the importance of the Angle value. With a high value the angular difference described
above is the important parameter in the margin line algorithm, while lower values result in the local curvature of the die
being more important in the margin line algorithm. The Smoothing slide bar defines the amount of post-processing applied
to the automatically extracted spline. The Show angle graphics checkbox enables or disables the advanced angle graphics.
The Set margin direction button defines the direction which best represents the current die and helps to place the more
precise margin line. Margin direction is visualized with the help of green arrows, as shown in the image above.