Download AAA 3.6 User Manual

Transcript
8.4.1.2.4
Distributed Weights
This option is provided to calculate and display the distributed weights from masses chosen in
the Select Compon. option. There are two choices in this section:
• Wi , Scg
If the distributed weights have been defined in the
Weight
module
(Chapter 1), those definitions will appear in the distributed weights
table and the program will distribute the weight over the entire
structural component to result in the specified center of gravity. If
this method is used the program will ignore the beginning and
ending locations and weights per unit length.
• W L , S1 , S2
If the beginning and ending locations and weights per unit length
are defined, the program assumes that the weight per unit length
varies linearly from the beginning location to the end location.
Fuselage distributed weights are assumed to be located along the centerline. When the Calculate
button is selected, the program will check the input of the distributed weight. The program
checks whether the distributed weight input is defined completely and logically. If there are any
errors, the program will display a message indicating what the error is. The program will check
both
Dist. Weights
options. The distributed weights table is flight condition dependent, and will
be reset for each new flight condition. The internal loads generated by each of the distributed
weights selected can be calculated in the
Total Internal
loads module using the data contained in
the distributed weights table.
8.4.1.3
User/Aerodynamic Loads
Any aerodynamic, control surface, flap, or user defined loads acting on structural components
can be defined in the Aerodynamic module for the wing, horizontal tail, canard or vertical tail. For
the fuselage, user defined loads can be defined in the User Loads module. The following options
are available when selected:
• Steady State
(Aerodynamic only) The steady state aerodynamic loads acting on
each lifting surface are defined separately as lift, drag, and pitching
II - 176
Loads