Download Current Manual - Sea

Transcript
Manual revision 007
Section 4: Deploying and Operating SBE 16plus-IM V2
SBE 16plus-IM V2
RS-232 Sensor Setup Commands (continued)
Note:
The 16plus-IM V2 sample interval
(#iiSampleInterval=) must be greater
than or equal to the sum of the times
required to sample. Total time is
affected by the following:
• Minimum time required for 16plus-IM
V2 to take a sample (≈ 2.5 sec).
• Time required for integration of
optional Quartz pressure sensor
(#iiParosIntegration=).
• Time required for 16plus V2 to take
and average #iiNCycles= samples;
samples are taken 0.25 sec apart.
• Delay after providing power to
external sensors before sampling
(#iiDelayBeforeSampling=);
minimum
#iiDelayBeforeSampling= is 2 sec
if using a WET Labs RS-232 sensor.
• Delay after sampling before turning
off power to external sensors
(#iiDelayAfterSampling=).
• Time required to run pump
before sampling (0.5 sec if
#iiPumpMode=1).
Setup for WET Labs Sensor
(single, dual, or triple ECO Sensor; WETStar, or C-Star):
• 16plus-IM V2 #iiDelayBeforeSampling= must be > 2 sec if
using a WET Labs RS-232 sensor. If #iiWetLabs=Y and
#iiDelayBeforeSampling < 2 sec, 16plus-IM V2 automatically sets
#iiDelayBeforeSampling=2.
• If using a WET Labs sensor with a bio-wiper – set 16plus-IM V2
#iiDelayBeforeSampling= and #iiDelayAfterSampling= to enough time
to allow bio-wiper to open before sampling and to close after sampling.
Sea-Bird typically sets this parameter to 4.0 sec for use with a sensor with
a bio-wiper (sensor dependent).
Note that the SBE 16plus-IM V2 stores and outputs 6 bytes of WET Labs
RS-232 data for each sample. If integrating an ECO Triplet, each sensor of the
Triplet uses 2 bytes (for a total of 6 bytes). If integrating a dual ECO sensor
(such as the FLNTU), the first 4 bytes contain the sensor data; the remaining
2 bytes are 0’s. For single WET Labs RS-232 sensors, the first 2 bytes contain
the sensor data; the remaining 4 bytes are 0’s.
#iiWetLabs=x
x=Y: Enable WET Labs RS-232 sensor.
x=N: Do not enable WET Labs RS-232
sensor.
62