Download Programming Manual, PowerFlex 700S AC Drive

Summary of Changes
New and Updated
Information
This table contains the changes made to this revision.
Topic
Page
Value 11 “Sleep Mode” was added to parameter 150 [Logic State
Mach] for firmware version 5.002.
45
Bits 21 “Sleep Stop” and 22 “Sleep Config” were added to
parameter 156 [Start Inhibits] for firmware version 5.002.
48
Value 8 “Sleep Config” was added to parameter 159 [DigIn
ConfigStat] for firmware version 5.002.
49
Bits 24 “Drv Waking” and 27 “RideThruAlrm” added to parameter
328 [Alarm Status 3] for firmware version 5.002.
73
Bit 2 “VltFdbkReCal” added to parameter 510 [FVC Mode Config] for
firmware version 5.002.
97
Bit 0 “PM Cogging” added to parameter 512 [PMag Mode Config] for
firmware version 5.002.
97
The following parameters were added for firmware version 5.002
Parameter No. / Name
Page
Parameter No. / Name
Page
278 [Sleep-Wake Mode]
66
534 [Nth CompOff Freq]
100
279 [Sleep-Wake Ref]
66
535 [Mth CompOff Freq]
100
280 [Wake Level]
66
594 [Nth Torq Compen]
106
281 [Wake Time]
66
595 [Nth Amplitude]
106
282 [Sleep Level]
66
596 [Nth Phase Shift]
106
283 [Sleep Time]
66
597 [Mth Torq Compen]
106
284 [Sleep Control]
67
598 [Mth Amplitude]
106
599 [Mth Phase Shift]
106
A new alarm "Drv Waking" (89) was added to the Fault/Alarm
Descriptions table.
157
Added a description of the new Sleep-Wake mode function to
Appendix B - Application Notes.
184
This table contains the changes made to the first release of the PowerFlex 700S
High Performance AC Drive - Phase II Control Programming Manual, publication
20D-PM001. This publication supersedes the PowerFlex 700S High Performance
AC Drive - Phase II Control User Manual, publication 20D-UM006.
Topic
Page
Added new MPM-series permanent magnet motor specifications.
215
Rockwell Automation Publication 20D-PM001B-EN-P - July 2011
3