Download CYCLOPS X-Purge Controller Users Manual

Transcript
63
(Leakage Compensation) Power Disconnect ByPass Switch Mode Maintenance or Service
Procedure:
The following procedure should be performed when using the CYCLOPS X – Purge
Controller, SM Version’s maintenance switch to perform maintenance or service on any
system in Power Disconnect By-Pass Switch Mode using an Automatic Leakage
Compensation Purge Gas Inlet Kit for any purged electrical equipment that uses the
CYCLOPS X – Purge Controller, SM Version to monitor and control the electrical
equipment enclosure purge pressure and power.
WARNING: Failure to heed the following, information may lead to
injury to personnel or equipment damage.
CAUTION:
Do not open the electrical equipment enclosure in a
hazardous area even when de-energized unless area has been
properly tested and is known to not contain explosive materials.
WARNING: Applicable permits must be obtained and appropriate
precautions must be taken to prevent possible injury to personnel or
equipment damage when using the CYCLOPS X – Purge Controller,
SM Version’s maintenance switch.
WARNING: Placing the CYCLOPS X – Purge Controller, SM Version
into Maintenance position disables safe operation of the system.
Maintenance mode is to be used ONLY when required for
maintenance or service AND ONLY if area is known to be nonhazardous.
CAUTION: Electrical equipment components may be hot even when
power is not applied. Take appropriate precautions to prevent injury
from contact with hot items.
NOTE: If required the CYCLOPS X – Purge Controller, SM Version’s
maintenance switch can be set to Maintenance position to provide
power to the electrical equipment mounted in the electrical enclosure
the CYCLOPS X – Purge Controller, SM Version is monitoring while
the enclosure door is open. When the maintenance switch is in the
maintenance position, the safety power shut off function is disabled!
Do not place the maintenance switch in the maintenance position
unless it is absolutely necessary and the area is known to be nonhazardous. As soon as maintenance or service is complete, the
maintenance switch MUST be placed in the Normal Operation
position.