Download esxupdate

Figure 1: Add Range of TCP/IP Hosts dialog box
The only prerequisite for this procedure is that the OneCommand Manager application must be installed
on all remote hosts.
To add a range of remote hosts:
1. From the Discovery menu, select TCP/IP > Add Range of Hosts.
The Add Range of TCP/IP Hosts dialog box appears.
2. Enter the complete start and end address range and click Add.
The added address range appears in the dialog box. Add any additional ranges you want to
search.
3. Click Start Discovery.
If an address is remotely manageable, it is added to the list of addresses that the discovery
server will attempt to discover. The utility creates a host file if necessary, and checks each
address in the range to determine if the host is available and remotely manageable. The number
of addresses (of manageable hosts) discovered is periodically updated on the dialog box.
4. To save the IP address ranges, click Save Ranges to File to save the specified range(s) to a file
so that these address ranges appear the next time you use the Add Range of TCP/IP Hosts
dialog box.
Drivers for VMware ESX/ESXi 4.1 - CIM Section
Page 16