Download MWS6-DD-LV - CP Electronics

Transcript
Wiring diagrams
Channel 1 (switched output) of the MWS6-DD-LV provides
a switched low voltage output which can be used to power
a mains load via an auxiliary relay or for other control
purposes. The optional –Gold is used for low current
switching and the optional –OC provides an open collector
output. See diagrams below.
Channel 2 (dimmable output) of the MWS6-DD-LV can be
used to control the light output of luminaires that are fitted
with dimming ballasts/transformers.
The ballasts/transformers can be connected in parallel to
Channel 2 (via the DIM– and DIM+ terminals). Refer to the
specification on page 12 for ballast quantities.
The wiring examples below show common methods of
connecting the output channels for a single detector unit.
Single channel dimming
Functions: Switches the luminaire with occupancy and maintains illuminance. Dims and switches using optional centre
biased retractive switch (MK K4900 or similar).
Configured to presence detection: Turns on automatically with occupancy. Maintains illuminance. Press and release
down switch to turn off. Press and release up switch to turn back on. Press and hold up switch to dim up, press and hold
down switch to dim down. Turns off after occupancy.
Configured to absence detection: Press and release up switch to turn on. Maintains illuminance. Press and release
down switch to turn off. Press and hold up switch to dim up, press and hold down switch to dim down. Turns off after
occupancy.
Channel
mode: channel
Set to “Switchdimming
and dim together”.
6.1 Single
OPTION
2: USING
CENTRE
RETRACTIVE SWITCH TO PROVIDE
Switch
mode:
Set toA “2
positionBIASED
switch together”.
INPUT
& SWITCH
SWITCHED AND DIMMING OUTPUT (STANDARD CONFIGURATION)
CONNECTIONS
DIMMING
BALLAST
DC Supply
AC Supply
OR 10VAC - 26.5VAC
11.5VDC
36VDC
DC Supply + AC Supply
11.5VDC - 36VDC
+
OR 10VAC - 26.5VAC
COM
OUT
COM
OUT +
+
DIMMING LUMINAIRE
(DSI or DALI)
DIM-
MOMENTARY PUSH TO
MAKE SWITCH
DIM+
SW1/UP
Optional for presence,
mandatory for absence detection
SW2
DOWN
CENTRE BIASED
RETRACTIVE SWITCH
Optional for presence,
mandatory for absence detection
EBDSPIR-DD-LV SENSOR
LOAD CONNECTIONS
-PRM-LV
-PRM-LV/GOLD
Load connection
LOAD
LOAD CONNECTIONS
-PRM-LV/OC
INTERNAL
RELAY
INTERNAL OPEN
COLLECTOR
TRANSISTOR
LOAD
COM
OUT
+
COM
OUT
+
6.4 Single channel switching
OPTION 1(B): USING A CENTRE BIASED RETRACTIVE SWITCH TO PROVIDE
ABSENCE DETECTION, WILL ALSO PROVIDE OPTIONAL OVERRIDE OFF.
5