Download USER`S MANUAL

Transcript
typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
Password on Boot enables or disables the entering of password (if existing)
for booting up your system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password or
not.
TPM Setup Menu sets various TPM parameters. Press Enter to access the
submenu as shown below.
Security
TPM Setup Menu
TPM Support:
Current TPM State:
Change TPM Status:
F1 Help
Esc Exit
Item Specific Help
This is used to
decide whether TPM
[Disabled and Deactivated] support should be
enabled or disabled.
[No Change]
[Enabled]
↑↓ Select Item
←→ Select Menu
+/Change Values
Enter Select  Sub-Menu
F9 Setup Defaults
F10 Save and Exit
TPM Support enables or disables TPM support. TPM (Trusted Platform
Module) is a component on your computer’s mainboard that is
specifically designed to enhance platform security by providing a
protected space for key operations and other security critical tasks.
Current TPM State shows the current TPM state.
Change TPM Status allows you to select between No Change, Clear,
Disabled and Deactivated, and Enabled and Activated.
5-12
Using BIOS Setup and System Recovery