Download USER`S MANUAL
Transcript
typing it again and pressing Enter. You can set the supervisor/user password to be required for starting up the system and/or entering BIOS Setup. Password on Boot enables or disables the entering of password (if existing) for booting up your system. Set HDD 0 Password sets the password for locking the Primary Master hard disk drive. After setting a password, the hard disk drive can only be unlocked by the password no matter where it is installed. HDD 0 Password Is shows whether you have set the hard disk password or not. TPM Setup Menu sets various TPM parameters. Press Enter to access the submenu as shown below. Security TPM Setup Menu TPM Support: Current TPM State: Change TPM Status: F1 Help Esc Exit Item Specific Help This is used to decide whether TPM [Disabled and Deactivated] support should be enabled or disabled. [No Change] [Enabled] ↑↓ Select Item ←→ Select Menu +/Change Values Enter Select Sub-Menu F9 Setup Defaults F10 Save and Exit TPM Support enables or disables TPM support. TPM (Trusted Platform Module) is a component on your computer’s mainboard that is specifically designed to enhance platform security by providing a protected space for key operations and other security critical tasks. Current TPM State shows the current TPM state. Change TPM Status allows you to select between No Change, Clear, Disabled and Deactivated, and Enabled and Activated. 5-12 Using BIOS Setup and System Recovery