Download TP3420A S Interface Device (SID) User`s Guide

Transcript
phased at 4 µs with respect to the leading edge of the derived clock. Also, in the fixed timing mode, the equalizer is
disabled.
Loopback Tests
Command
Status
LBS
LBL1
LBL2
LBB1
LBB2
CAL
4.5 TP3420A Line Signal Detect (LSD) and Wake-Up
Signal for µP
The Line Signal Detect circuit in the SID is active when the
device is in the power down state. Upon detecting a valid signal, the LSD pin on the device is pulled low from its normally
high impedance state, and also the LSD bit in the Status
Register is set. The LSD pin may be used for waking up a local microprocessor from a low power idle mode and subsequently powering up SID itself. The LSD pin goes into the
high impedance state upon powering up (PUP) the SID and
the LSD circuit in the device is disabled in powered-up
mode.
4.4 TP3420A Receive Timing Recovery
The TP3420A has two receive clock timing options available
in its system implementations as shown in the conceptual
diagram of Figure 18.
In adaptive timing mode, the DPLL is locked to timing in the
received bit stream. This mode is used in TE applications for
both point-to-point, short and extended passive bus configurations, whereas in NT mode this is used for point-to-point
and extended passive bus configurations only.
For application in the NT of a short passive bus only, the multiple TE’s with different round trip delays cause wide variations in the zero crossings so that a DPLL cannot generate a
clean clock reliably. Therefore the receive sampling DPLL is
bypassed in this mode by selecting the NTF command. In
Fixed timing mode, the DPLL is locked to TXCLK and
Figure 19 shows a simple concept of using the LSD pin on
the TP3420A SID in waking up HPC16400E, the local microcontroller. The LSD signal is tied to the NMI pin of the
HPC16400E. When a remote activation request is sensed by
the SID, it pulls the LSD pin low and the NMI pin detects the
inverted LSD signal to wake-up the HPC16400E. The INT
signal on the TP3420A SID may also be used for these
wake-up procedures because the LSD bit in the status register may be read upon the INT signal going low.
AN010730-27
TP3420A SID has 2 RX CLK Timing Options:
1. DPLL Adaptive timing, locked to RX data
Used in TE mode always
Used in NT mode for point-point only
2. Fixed Timing, locked to TX CLK and phased at 4 µs after TX edges
Used in NT mode for passive bus only
The NT/TE bits select both the timing mode and the state machines for activation control.
FIGURE 18. TP3420A Receive Timing Circuitry
www.national.com
20