Download Automatic Gas Console

Automatic Gas Console Advanced Functions
FineLine 260PC User’s Manual
Altering Gas Pressures
Normally, the preflow gas and plasma gas pressures should not be changed. The
shield gas is normally adjusted in small increments to fine-tune a cut. To alter the
gas pressures, use the arrow keys to scroll to the appropriate pressure setting. The
pressure setting should be highlighted as shown in Figure 5-4 and the editing
cursor should be blinking. Use the numerical keypad to enter the desired
operating pressure. Use the CLR key to backspace if an error is made. Press
ENT when the correct value has been entered. Note that all of the gases have
minimum and maximum limits and cannot be programmed beyond these limits.
Figure 5-4 Altering Gas Pressures
5-4