Download 17.15 Removing Red Hat Linux

Transcript
Section 6.1:Using RP3 to Connect
Figure 6–5
The Edit Modem Properties Dialog
In the Edit Modem Properties dialog, you can specify the location of your modem, its
baud rate, your preference regarding the speaker volume during a call and whether to
use Touch Tone dialing.
Although RP3 attempts to detect the correct port, you can adjust the settings here.
If you know that your modem is attached to COM2 under Windows, for example, its
location in Linux will be /dev/ttyS1. Here is a comparison of serial line names
in MS-DOS (and Windows) and Linux:
•
COM1 = /dev/ttyS0
•
COM2 = /dev/ttyS1
•
COM3 = /dev/ttyS2
•
COM4 = /dev/ttyS3
Using the drop-down list in the Modem Device box, enter the port to which your modem is connected. Then, in Baud Rate, enter the fastest recommended speed for your
97