Download Axis Control Unit MT3USBMS USER MANUAL

Transcript
Axis Control Unit
MT3USBMS USER MANUAL
MOTOR CONNECTION (6 LEAD MOTORS)
Half coil configuretion
This configuretion uses 50% of the motor phase windings. This gives lower inductance, hence, lower torque output. Like
the parallel connection of 8 lead motor, the torque output will be more stable at higher speeds. This configuretion is also
referred to as half copper.
Fase A+
Fase ANon connesso
Fase B+
Fase BNon connesso
Figure 10: half coil configuretion.
Full coil configuretion
The full coil configuretion on a 6 lead motor should be used in applications where higher torque at lower speeds is desired.
This configuretion is also referred to as full copper.
Fase A+
Non connesso
Fase AFase B+
Non connesso
Fase B-
Figure 11: full coil configuretion.
23
IPSES S.r.l. Via Suor Lazzarotto, 10 - 20020 Cesate (MI) - ITALY
Tel. (+39) 02 39449519 Fax (+39) 02 700403170
http://www.ipses.com e-mail [email protected]