Download LEDBAR5QUADO - Lightsounds

•
•
•
The unit must be installed in a location with adequate ventilation, at least 50cm
from adjacent surface. Be sure that no ventilation slots are blocked.
Always disconnect from power source before servicing or replacing fuse and be
sure to replace with same fuse source.
Secure fixture to fastening device using a safety chain. Never carry the fixture
solely by its head. Use its carrying handles.
•
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always use
the same type spare parts.
•
•
•
•
Never connect the device to a dimmer pack.
Make sure power cord is never crimped or damaged.
Never disconnect power cord by pulling or tugging on the cord.
Avoid direct eye exposure to the light source while it is on.
INSTALLATION:
CAUTION: For safe mounting, read the following
instructions carefully:
• Use suitable hook clamps for hanging the lighting effect.
• Use a safety wire with a breaking strain of more than
double the lighting effect.
•
•
Do not look directly into the light source.
•
This lighting effect is intended for indoor use only to avoid
electrical shock keep away from rain and moisture.
•
Keep unit out of reach from children.
Make sure the lighting effect has suitable ventilation as per
the instructions below.
NOTE: Use washers and spring washers when attaching your hook clamp to the yoke.
1. For installation of the hook clamps and safety wire.
2. This lighting effect must be 0.5m away from any flammable materials or any walls or
ceilings.
3. Do not block or inhibit the air flow from the ventilation vents.
Light Emotion has various hook clamps and safety wires suitable for your
MUSHROOMLED. Please contact your local dealer for more information.
MAINTENANCE & PERIODIC CHECKS:
CAUTION: Some maintenance and checks may require the product to be opened and
should only be done by qualified persons. Warranty may be void if damage has been
caused by improper maintenance Perspex lenses should be wiped with a clean moist cloth
to remove dust and residue.
3