Download GSK983Ta User Manual

GSK983Ta Turning CNC System User Manual
omit the block and setting procedures.
Backlash compensation
The mechanical wearing compensation is executed on the machine side. Each
axis can independently take the minimum movement unit as the unit, and the
42
compensation amount can be set as the parameters in the range of 0～255.
43
Absolute/incremental
Specify the absolute command with addresses X and Z, the incremental one
command
with U, W.
These address words can be specified in one block.
The data are sent to NC from the machine outside, and the specified operation
is executed. The types corresponding to the external data are as follows:
44
External data input
Chapte 3
Tool offset
（1）
External workpiece number search C
（2）
External tool compensation C
（3）
External alarm information
（4）
External operator information
One lowest valid digit in T code (T code of two digits) or the lowest two valid
CNC Specification and Configuration Function
digits (T codes of four digits) specify the tool offset number. The offset value
45
corresponding to the offset number must input from MDI key and register into
the memory. The offset compensation of 32 groups is standard, and 64 groups
can be selected.
Manual
46
absolute
ON/OFF
Whether the distance of the tool is moved by manual operation is added to the
coordinates can be selected by turning the manual absolute switch on or off on
the machine operation panel.
Manual absolute switch
47
Override cancel
ON: Add
OFF: Not add.
The cutting feedrate can be fixed in 100% through the signal from the machine
side.
Manual continuous feed
（1）
JOG feeding
JOG feedrate can be switched in 24 levels with the rotary switch; the ratio
is in 24 equal levels. And the standard panel is divided into 20 levels.
48
（2）
Manual rapid feeding
The rapid feeding can be operated in Jog mode, the rapid feedrate is set
by parameters.
Incremental feed
The following incremental feeding amount can be positioned, so the manual
position can be executed in high efficiency.
49
（Incremental feeding amount）
0.001；0.01；0.1；1；10；100mm (Input in metric system)
0.0001；0.001；0.01；0.1；1；10inch (Input in inch system)
Reference position
The reference position return A has the following contents:
return A
（1）Manual reference position return
（2）Reference position return check (G27)
50
（3）Automatic reference position return (G28)
（4）Return from the reference position (G29)
51
200
Reference position
The reference position return B not only has the function of the reference
return B
position return A, but also has the 2nd reference position return (G30).