Download 123 Print User Guide
Transcript
Chapter 1 : Primer 1.3. Project Flow General introduction 123 Print structures your project flow using a combination of screens and processes that you create via 123 Print’s User Interface and Labels. This section gives a high level view of the flow and interrelationship between the screens that are created via the User Interface and those created via Labels. With User Interface, you can print any static label you want. With Labels, you can change a static label into a dynamic label by merging in variable data from data collection, user screen prompts, and processing logic. Please reference Section 3.2 – User Interface and Section 3.3 – Labels for detailed information about these functions. User Interface Every 123 Print project follows a pre-defined screen flow. You configure these screens through the User Interface function. This is the only screen flow function you need if you want to print static labels. This core flow is depicted here. Your Project Name Ver 1.00 Select Label: <Label Name> <Label name> Qty to Print: The first screen 1 1 2 3 is a Welcome screen. The second screen 2 is the Select Label screen. 3 is the Quantity to Print screen. www.mcl-collection.com The third screen These screens are displayed in a black font on the Datamax printers. When your 123 Print project is run on the printer, it first displays the Welcome screen. It then goes into a loop alternating display between the Select Label screen and the Quantity to Print screen. Your application will loop infinitely between the second and third screens until you press the Menu (ESC) button on the front panel of the Datamax printer. As you design your project in 123 Print, you have the option to customize the Welcome screen. By default 123 Print proposes your project name for the Welcome screen. You then add the labels you want to be able to print from your project. When your project is run, this list of labels is presented on screen (2). The user presses the Fwd ↑ and Rev ↓ buttons on the printer’s front panel to scroll through the list of available labels and, by pressing the Ent ↵ button, selects the label that is required for a given operation. Here is an example of what screen (2) might look like on a printer when the fourth label in your project is a label for pallets: October 2007 Copyright © 2007 • MCL Technologies • All Rights Reserved Page 9