Download User Manual - Quinn
Transcript
SPC Variable Control Charts 161 Control Limits for the MR part of the MAMR (Moving Average/Moving Range Chart Control Limits for the R-Chart _ UCL = R + D4 * Center line = _ R LCL = 0 _ R _ R in this case is the average of the moving ranges. Where the constant D4 is tabulated in every SPC textbook for various sample sizes. Control Limits for the MS part of the MAMS (Moving Average/Moving Sigma Chart UCL = _ B4 * Center line = _ S LCL = _ B3 * _ S _ S _ S in this case is the average of the moving sigmas. Where the constant B4 is tabulated in every SPC textbook for various sample sizes. The software does not calculate an optimal Nvalue; that is up to you, the programmer to supply, based on your past experience with MA charts. For the values of zi where i < N-1, the weighted average and control limits are calculated using the actual number of samples used in the average, rather than N. This results in expanded values for the control limits for small i < N-1. You specify N, the length of the moving average, immediately after the initialization call initSPCTimeVaraibleControlChart (for a time-based variable control chart), or initSPCBatchVariableControlChart (for a batch-based variable control chart). Set the
Related documents
QCSPCChart SPC Control Chart Tools for Java - Quinn
QCSPCChart SPC Control Chart Tools for - Quinn
User Manual - Quinn
QCSPCChart SPC Control Chart Tools for .Net CF - Quinn
QCChart2D for WPF User Manual - Quinn
Modeling and Implementation of PID Control for Autonomous Robots
CIMPLICITY SPC Operation Manual