Download Installation Guide

Illustration 12: Assembled Solar Panel,
(exposure side facing down)
Next, mount the assembled solar panel to the actual base
station pole and secure the panel to the pole using the
included U-bolt and flat bracket. Finish by turning the
panel to a straight south exposure. The bracket should be
made for at an appropriate angle to the sun for your
location, typically 45 degrees for California.
If using a drilled ABS Pipe, gently pull the cable down
through the pipe and out an adjacent hole just below the
Base Station.
Plug the solar panel cable into the Base Station: Port 1
(See Illustration 5 in the next section), this will cause the
Base Station to start-up (even without sunlight).
Now follow the Verification Steps in Sections 2 & 3 to
assure you have a reliable connection to the Ranch
Systems servers.
22
© Ranch Systems LLC, 2005-2008. All Rights Reserved. Reproduction without permission from Ranch Systems is prohibited.