Download HP OpenView VantagePoint Performance Agent

Installing MeasureWare Agent
Installation Procedures
Installation Procedures
MeasureWare Agent is on the CD-ROM installation media in several filesets.
The size of the product is approximately 30 MBs.
MeasureWare Agent installation is done in two phases: First, you stop any
performance tools or processes that may be running. Then, you install the
product. (For additional information on installation procedures, see the
Managing HP-UX Software Manual or the HP OpenView Software
Distributor Administrator's Guide.)
To stop active performance tools or processes:
1. Log in as root.
2. Run perfstat to check for active performance tools by typing
/opt/perf/bin/perfstat
If perfstat reports any active performance tools such as GlancePlus, stop
them. (Before doing so, make sure that none of your users are currently
using these tools.)
3. If a previously-installed version of MeasureWare Agent is running, you
must stop it by typing:
/opt/perf/bin/mwa stop
(Customized configuration files such as the parm, alarmdef, ttd.conf,
and perflbd.rc files as well as any customized log files will not be
overwritten by the new installation.)
4. Make sure the midaemon (measurement interface daemon) is not active
by typing:
ps -ef | grep midaemon
If the midaemon is still active, type:
/opt/perf/bin/midaemon -T
5