Download Resolution Direct Vent Gas Fireplace

SECURe FIREPLACE to floor or framing
Resolution Direct Vent Gas Fireplace
The fireplace must be secured to the floor and/or to framing studs as shown in Figure 6. Use two
(2) wood screws or masonry/ concrete screws to secure fireplace to the floor. Use four (4) screws
to attach fireplace to framing. The side nailing flanges are 1/2" or 5/8" to accommodate different
wall thickness.
Framing Members
Noncombustible Material
6”
Noncombustible
Material Must Rise
at Least to Top of
Stand off
Figure 6 Secure Fireplace to Floor
and Framing Studs
Secure to Floor Behind
Access Panels
FP2130
note
Nailing Flange
All Combustible Materials
Must Keep 3/4" Spacing
Never install combustible materials
over front face of fireplace.
FP2130
secure fireplace to floor
Finishing Material
NOTE: Any remote wiring (i.e. remote control, wall switch, and optional fan) must be done prior to
final finishing to avoid costly reconstruction.
Only noncombustible materials (i.e. brick, tile, slate, steel, or other materials with a UL fire rating of
Zero) may be used to cover the black painted face of the appliance. It is permissible to bring combustible wall board to the top of the stand-offs on the top and the sides of the unit. A 300°F minimum
adhesive may be used to attach facing materials to the black surface. If joints between the finished
wall and the fireplace surround are sealed, a 300°F minimum sealant material (General Electric
RTV103 or equivalent) must be used.
10
20300293