Download Manual - Schlumpf, Inc

Equipment Specifications And Capacities
The capacity for the stacker tooling is clearly labeled on the unit itself.
Examples of capacity label and chart on Armanni unit
Refer to Stacker User manual for operating the stacker unit
Power Source:
(2) 12 volt DC sealed lead-acid batteries in series for 24 volt DC
output or 24 VDC wet cell traction batteries.
Operating Controls:
Push buttons or precision hydraulic lever valves.
Power Transmission for Toolings:
Electric linear actuators, hydraulic cylinders
DO NOT OVERCLUTCH ACTUATORS! ELECTRIC ACTUATORS ARE EQUIPPED
WITH A SLIP CLUTCH FOR REACHING END-OF-STROKE. DO NOT LET ACTUATOR CLUTCH RATCHET CONTINUOUSLY. OVERCLUTCHING ELECTRIC ACTUATORS WILL CAUSE PREMATURE WEAR AND DAMAGE!
Page
5
Schlumpf, Inc., 39 Enterprise Drive, Windham, Maine 04062 U.S.A.
Tel: 207-893-1903. Fax: 207-893-1905.
Internet: www.schlumpf-inc.com. www.armanni-usa.com. E-mail: [email protected]
Armanni Stackers w/Custom Tooling User Manual
The Schlumpf tooling is clearly labeled with a load capacity sticker. Do not exceed the maximum roll weight.
Serious injury or equipment damage will result!
Example of capacity label and chart on Schlumpf unit*:
(*actual weight, width and diameter capacities will vary!)
Schlumpf, Inc.
* Batteries not covered under warranty