Download User Manual - Charter Controls
Transcript
The number setting of Q,I,AQ are continuous .AQ12 cannot be set as AQ 12 and should be set AQ 4 as above figure shows. The following table shows how to set. Note: this table also can be applied for the configuration of Modbus Write function block. Model I,Q,AI,AQ Dialog box set CPU I1-I8 I1-I8 Q1-Q4 Q1-Q4 AI1—AI8 AI1—AI8 AQ1—AQ2 AQ1—AQ2 Expansion1 I11-I14 I9-I12 (Address is 1) Q11-Q14 Q9-Q12 AI11-AI14 AI9—AI12 AQ11-AQ12 AQ3,AQ4 Expansion2 I21-I24 I18—I21 (Address is 2 Q21-Q24 Q17—Q19 AI21-AI24 AI17---AI24 AQ21-AQ22 AQ5--AQ6 186
Related documents
C:\Documents and Settings\chennaifa\桌面\xLogic user`s manual_new
xLogic user`s Manual
Ethernet Module Manual
SuperRelayManual SuperRelayManual
Returnstar Interactive Tech IQTouchScreen User manual
INSTALLATION & OPERATING INSTRUCTIONS MODELS
Untitled
Ethernet User Manual
OBS-18 OBS-18DC
CX Series User Manual
Cable Electronics 1001ST User's Manual
IQ Interactive Education Platform User Manual