Download SPACAR User Manual

Transcript
Section 3.2. Planar slider–crank mechanism
49
>> plot(t,[xd(:,lnp(2,2)) ...
-(-3ˆ(1/2)+t)./(1+2*3ˆ(1/2)*t-t.ˆ2).ˆ(1/2)])
>> grid
>> xlabel(’time [s]’)
>> ylabel(’(d/dt) y(2) [m/s]’)
>> figure
>> plot(t,[xdd(:,lnp(2,2)) ...
4./(-1-2*3ˆ(1/2)*t+t.ˆ2)./(1+2*3ˆ(1/2)*t-t.ˆ2).ˆ(1/2)])
>> grid
>> xlabel(’time [s]’)
>> ylabel(’(d/dt)ˆ2 y(2) [m/sˆ2]’)
Obviously, in both graphs the symbolic and numeric results are practically identical, which
illustrates the good agreement between both solutions.
Note that in this example no masses are defined. There are no dynamic degrees of freedom
either, so effectively only a kinematic problem is solved.
3.2
Planar slider–crank mechanism
The slider–crank mechanism is frequently applied as a subsystem in the design of a mechanism.
It finds its applications in combustion engines, compressors and regulators. Figure 3.4 presents
a slider–crank mechanism for which three dynamics computations have to be carried out. In
the first problem (case 1, see also example 5.7.2 in the lecture notes [1]), the crank and the
connecting rod are assumed to be rigid. In the second computation (case 2), the connecting rod
is shorter but still somewhat longer than the crank. In case 3, the flexibility of the connecting
rod with the dimensions of case 1 is taken into account; see also example 8.3.1 in the lecture
notes [1].
Case 1
First of all, the nodal coordinates must be specified. In the initial configuration, the crank and
the connecting rod are horizontal. The crank length is 0.15 m, the length of the connecting rod
y
x x
~3, 4 , 5
B
1m
2m
ω0
x
x
~1, 2
~6, 7
A
x
C
Figure 3.4. Planar slider–crank mechanism.