Download User Manual

Operation
To now change communication from SDI-12 to RS232.
Type COMMS RS232 and press Enter.
Type Q and press Enter to exit SAFE MODE.
Data will now scroll on screen.
Note however for RS232 changes to take place the unit must be powered
down and back up again.
Close the 4800 baud rate Wind or HyperTerminal Program.
Power down the MetPak Pro and re-apply power.
Open a new Wind or HyperTerminal program at 19200 baud rate.
RS232 data will now scroll on screen at the MetPak Pro default 19200-baud rate.
MetPak Pro User Manual
© Gill Instruments Ltd
Page 56
Last Change
08 February, 2013