Download GSM Remote Control System

3.7 User manual
use the system as it is. To avoid any operating problems it is recommended that the administrator
check the default settings. This is recommended as these settings might not suit the environment
and application in which the system is installed. After the initialization has been completed, the
system returns to normal operation.
Local Administrator
When using the local interface, the current system status is displayed on the LCD as shown in
3.5. This menu is displayed on the LCD, when the system is in normal operation. In the status
menu the current temperature, time, control unit and GSM status is displayed. To activate the
menu system, simply press any key on the keypad.
C. Temp
Control
Time
GSM
13o C
OFF
12.30
Online
Table 3.5: The menu displayed on the LCD during normal operation.
Main Menu
User
Reset user
Administrator
1
2
3
Table 3.6: The main menu.
Administrator menu
Select the administrator menu by pressing 3, while in the main menu. When trying to access the
administrator menu, administrator or user must enter the administrator phone number, to confirm
administrator rights. The administrator number, is the number, that was entered during the initialization of the system.
Temperature Default: 21◦C
Select Set, enter the desired temperature.
Entering an invalid temperature (out of range) or a temperature conflicting with the set alarm
temperatures, will clear the entered values. Please select a different temperature or contact the
administrator. The menu can be seen in table 3.13 in the "User Guide".
30 af 166
3. System Analysis