Download Richter Data-Acquisition unit

Applied Seismology Consultants
Richter
16
User Manual
2.3.2.1 Setting up the Pulser-Amplifier Desktop Units
1. The PADs are connected to the other systems through a Cable Assembly. Figure 2-10 shows how
the connections are made.
Figure 2-10: Connecting the PAD Unit.
Step-by-step guide:
2. Connect the transducer BNC connector to the PAD Unit “Sensor in” BNC connector.
3. Connect the 6-pin female connector from the Cable Assembly to the 6-pin male connector labelled
“CONTROL”.
4. Connect the two BNC connectors of the Cable Assembly to the two output BNC connectors of the
PAD Unit labelled “OUT 1” and “OUT 2”
Richter User Manual
11 February 2014
xix