Download NuForce AVP-16

Transcript
remote and inserting them into the slide-out battery carrier while observing the
correct positive and negative polarity markings.
Using the remote control to access the MENU and make adjustments is simple.
Pressing the MENU button displays the main MENU, pressing the down or up
menu arrows allows scrolling through the sub-menu’s (just like rotating the
Function knob). Pressing the “OK” button to the right of the MENU button allows
you to select different inputs, modes, and functions, just as pressing in the Function
knob does. Using the down or up arrows allows you to change the values of the
settings. When a setting is finalized press “OK” to save the setting then press the
down or up arrows to scroll through other items on the sub-menu. Press the “Exit”
button to the left of the MENU button to return to the previous sub-menu. Pressing
the VOLUME buttons below the MENU keys will return you to your previously
selected INPUT and VOLUME settings at any time.
To adjust the tone controls using the remote, first press the MENU button and then
press the down arrow twice to scroll to the “AUDIO SETUP” sub-menu. Pressing
“OK” will bring up “ADJ Treble,” pressing “OK” again will show “Treble 00.”
Using the down or up arrows decreases or increases the treble +/-10dB, in 2dB
steps. To set, press “OK” to save the setting and then the down arrow to proceed to
the “ADJ Bass” mode. Once the tone controls are set, you may continue in the
Audio Setup sub-menu to make speaker level adjustments for each of the seven
speaker channels plus the subwoofer, or push the Volume buttons to return to your
last selected input and volume setting.
7.1 Channel Volume Adjustment
1. Pressing the remote control short-cut buttons for “CENTER,” or “SUB,” followed
by pressing the VOLUME keys will provide instant volume control for these two
critical audio channels. After about 10 seconds the display will return to the prior
input and volume settings.
2. Using the remote, press MENU and then press the down arrow twice to scroll to
the “AUDIO SETUP” sub-menu. Pressing “OK” will bring up “ADJ Treble.”
Keep pressing the arrow to go to “ADJ Bal-L,” which refers to the volume of the
left main speaker. Pressing “OK” shows “Bal-L 00.” Using the down or up
arrows decreases or increases the left main speaker volume +/-10dB, in 2dB
steps. Once set, press “OK” to save the setting and then the down arrow to