Download 700 Series User Manual

LaCie 700 Series LCD Monitors
User Manual
Copyrights
Forward
page 2
user is encouraged to try and correct the
interference by one or more of the following measures:
Copyright © 2008 LaCie. All rights reserved. No part of this publication may
be reproduced, stored in a retrieval system, or transmitted in any form or by any
means, electronic, mechanical, photocopying, recording or otherwise, without
✦✦ Reorient or relocate the receiving antenna.
✦✦ Increase the separation between the
equipment and receiver.
✦✦ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
✦✦ Consult the dealer or an experienced
radio/TV technician for help.
✦✦ Use only shielded cables to connect
I/O devices to this equipment.
the prior written consent of LaCie.
Changes
The material in this document is for information only and subject to change
without notice. While reasonable efforts
have been made in the preparation of this
document to assure its accuracy, LaCie
assumes no liability resulting from errors
or omissions in this document, or from the
use of the information contained herein.
LaCie reserves the right to make changes
or revisions in the product design or the
product manual without reservation and
without obligation to notify any person of
We, LaCie, solemnly declare that this
product conforms to the following European standards:
✦✦ EN60950-1, EN61000-3-2
✦✦ EN61000-3-3, EN55024
With reference to the following conditions:
✦✦ 73/23/EEC Low Voltage Directive
✦✦ 89/336/EEC EMC Directive
LaCie S.A.
Use the attached specified cables with the
LaCie 700 Series color monitor so as not
to interfere with radio and television reception.
1. The power supply cord you use must
have been approved by and comply
with the safety standards of U.S.A. and
meet the following condition.
such revisions and changes.
FCC Declaration of Conformity:
Power supply
chord
LaCie 720, 724 & 730
LCD Monitors
Length
Tested to comply with FCC
standards for home or office
use
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the
Manufacturer’s Declaration
for CE Certification
Non shield type,
3-conductor
2.0 m
Plug shape
(USA)
2. Please use the supplied shielded video
signal cable, 15-pin mini D-SUB to
DVI-A cable or DVI-D to DVI-D cable.
Use of other cables and adapters may
cause interference with radio and television reception.
U.S. Responsible Party: LaCie, LTD
Address: 22985 NW Evergreen Pkwy
Hillsboro, OR 97124
Tel. No.: (503) 844-4503
33 Bld du Général Martial Valin
75015 Paris
France
CAUTION: Modifications not authorized by the manufacturer may void the
user’s authority to operate this device.
Modifications not authorized by the
manufacturer may void the user’s authority to operate this device.
CAUTION: A shielded-type power cord
is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television
reception. It is essential that only the supplied power cord be used.