1
Download USER`S GUIDE
Transcript
BASIC PROGRAMMING B2 WIRING TYPE WITHOUT MONITORED SAFETY DEVICE C D Requires a non-monitored safety device. • Momentary contact to open, close and stop. • Open override that reverses when closing by any opening device. • Wiring for safety device to reverse. NOTE: The operator will automatically convert to B2 wiring (option D) when Monitored Safety Device is installed. (See accessories page for Monitored Safety Devices) • Timer to Close (TTC) feature not available. B2 WIRING TYPE WITH MONITORED SAFETY DEVICE • Momentary contact to open, close and stop. • Open override that reverses when closing by any opening device. • Wiring for safety device to reverse. NOTE: The operator will automatically convert to B2 wiring when Monitored Safety Device is installed. (See accessories page for Monitored Safety Devices) • Timer to Close (TTC) feature available. NON-MONITORED SAFETY DEVICE MONITORED SAFETY DEVICE Sensing Edge Photo Eye TO PROGRAM NO PROGRAMMING REQUIRED Start with operator in factory default C2 mode. Press and hold the LEARN and CLOSE buttons until the LED goes out (approximately 3 seconds). Electrical Box Logic Board D7 U4 D6 014A1030 C20 D5 D4 J4 C32 R25 C31 TP1 C9 U1 C21 LEARN L5 ^^^^ AUX AUX ANT ANT C18 R27 J2 STOP CLOSE OPEN D14 TTC LEARN STOP CLOSE OPEN LED D9 1 2 3 4 5 6 7 LMEP1 LMEP2 COM INTRLK STOP CLOSE OPEN K2 LT C29 R24 P1 D14 LED 1 2 3 4 5 6 7 3
