Download rl 1600 reference guide

Model RL1600
QUICK REFERENCE GUIDE
SPEEDY BUCK ATM
PO Box 3175 - Lubbock, Texas 79452-3175
806-239-4931
PO Box 12351 - El Paso Texas 79913
915-351-1093
TDN 007103-00187
May 1 2009
0$1$*(0(17)81&7,216
$&&(66 ,16758&7,216
$7$70:(/&20(6&5((135(66$1'+2/''2:17+(&75/!
.(< / 2:(5 5,*+7 &251(5 2) .(<3$' 35(66 !.(< 7+(1 5( /($6( %27+ .(<67+( 723 0(18 :,//%(',63/$<(' $77+(7230(186(/(&70$1$*(0(17)81&7,216237,21(17(5
3$66:25' $1' 6(/(&7 ( 17(5 !7+( 0$1$*(0(17 ) 81&7,216
0$,10(18,6',63/$<('
5(67$576+87'2:17(50,1$/
)2//2:$&&(66,16758&7,21672(17(50$1$*(0(17)81&7,2166(
/(&76<67(03$5$0(7(56
5(67$577(50,1$/7+,6)81&7,215(%22767+(7(50,1$/
6+87'2:17(50,1$/7+,6)81&7,2132:(56 '2:17+(7(50, 1$/623(5$7,1*6<67(0:+(1352037('7+$76+87'2:1,6 &203/(7(
785121 2)) 6:,7&+21 32:(56833/< 722))!326,7,21
',$*1267,&6
)2//2:$&&(66,16758&7,21672(17(50$1$*(0(17)81&7,2166(
/(&7',$*1267,&6!',63(16(5
385*(7+,6,16758&767+(',63(16(5725(029($1<127(6-$06,1
)(('3$7+
7(67',63(16(7+,6,16758&767+(',63(16(572',63(16(0,1,080
21( 127( )520 ($&+,167$//(' &$66(77( ,172 7+( 5(-(&7 &$66(77( $5($ 6(/(&7',$*1267,&6!35,17(5
5(6(77(675(&(,3735,17(57+,6,16758&767+(35,17(5725(
,1,7,$/,=($1'3(5)250$7(6735,17287
&/26()81&7,216
)2//2:$&&(66,16758&7,21672(17(50$1$*(0(17)81&7,2166(
/(&77(50,1$/&/26()81&7,216
'$<&/26(7+,6237,21,686('72&203/(7('$,/<%$/$1&,1*2)7+(
$70:,7+7+(352&(6625727$/6$5(&/($5('$1'6:,7&+('727+(
1(;7%86,1(66'$<
75,$/&/26(7+,6237,21)81&
7,216/,.($'$<&/26((;&(377+(
727$/6$5(127&/($5('
-2851$/)81&7,216
)2//2:$&&(66,16758&7,21672(17(50$1$*(0(17)81&7,2166(
/(&7-2851$/
35,17/$67;72 9,(:35,17 35(9,286/< $8',7(' 25 81$8',7('
5(&25'686(7+(35,17/$67;237,21
(;$03/((17(5,1* 7+( 180%(5µ¶:,// /(7<28 9,(: 7+(/$67 75$16$&7,216(9(176 7+$7 +$9( 2&
&855('<280$<35,17727+(5(&(,3735,17(5
7(50,1$/&21),*85$7,215(3257
)2//2:$&&(66,16758&7,21672(17(50$1$*(0(17)81&7,2166(
/(&7',$*1267,&6!7(50,1$/67$786
&21),*85$7,216800$5<7+,66800$5<,6$&2035(+(16,9(
5(32572)&855(177(50,1$/&21),*85$7,21$1'+$5':$5(67$786,1
)250$7,21
127(,7,6+,*+/<5(&200(1'('7+$77+,65(3257%(35,17('$1'6$9('$)7(5,1,7,$/6(783$1':+(1(9(5
&+$1*(6$5(0$'(727+(7(50,1$/6&21),*85$7,21
CASSETTE CLOSE FUNCTIONS
FOLLOW ACCESS INSTRUCTIONS TO ENTER MANAGEMENT FUNCTIONS. SELECT TERMINAL CLOSE FUNCTIONS.
SELECT CASSETTE CLOSE.
nSELECT CASSETTE(S) TO CLOSE. A CHECK MARK (— ) IDENTI- qAFTER CASSETTE(S) HAVE BEEN REINSERTED IN THE DISFIES WHICH CASSETTE(S) ARE SELECTED.
PRESS <ENTER>.
PENSER, PRESS
<ENTER>.
rPLACE SELECTED CASSETTE(S) IN SERVICE.
TER>.
oA CLOSE REPORT IS DISPLAYED TO BE PRINTED OR SAVED.
THIS
PRESS <EN-
OPERATION WILL RESET THE NUMBER OF BILLS IN THE
CASSETTE(S) TO
ZERO (0). PRESS <ENTER>.
sENTER
CASSETTE QUANTITY (NUMBER OF NOTES, NOT
PRESS <ENTER> TO
ACCEPT ENTRY. REPEAT FOR EACH SELECTED CASSETTE.
VALUE) FOR THE SELECTED CASSETTE(S).
pREMOVE AND REPLENISH THE SELECTED CASSETTE(S).
PROCEDURES FOR SPECIFIC DISPENSING MECHANISMS CASSETTE REPLENISHMENT ARE ON THE FOLLOWING PAGES.
tA TRIAL CASSETTE CLOSE REPORT AUTOMATICALLY IS
DISPLAYED TO BE PRINTED OR SAVED.
PRINT AND RETAIN A COPY
FOR STARTING POINT REFERENCE. PRESS <ENTER> TO RETURN TO
CLOSE FUNCTIONS.
4
REPLENISH MINI MECH CASSETTE
STEP
ACTION
1
UNLOCK/OPEN DISPENSER SECURITY DOOR. GRASP
TRAY HANDLE AND REMOVE NOTE CASSETTE
ACTION
STEP
2
REMOVE
5
PLACE
CURRENCY IN THE CASSETTE.
6
GRASP
THE HANDLE AND SLIDE THE NOTE CASSETTE
PACKER FORWARDS AGAINST THE NOTES.
SLOWLY
PUSH
ANY REJECTED NOTES FROM THE REJECT
COMPARTMENT.
DO NOT RECYCLE REJECTED NOTES!
3
MOVE THE PUSHER PLATE TO THE REAR OF THE TRAY
(TOWARDS THE HANDLE).
4
COUNT
THE NUMBER OF BILLS THAT REMAIN IN THE
CASSETTE, IF ANY.
COUNT THE NUMBER OF BILLS THAT ARE BEING ADDED
TO THE REMAINING NOTES.
THE TOTAL OF THESE AMOUNTS WILL BE ENTERED
IN THE “ENTER CASSETTE QUANTITY” PROMPT FOR
CASSETTE CLOSE PROCEDURE.
5
FULLY INTO THE DISPENSER.
REPLENISH RECEIPT PAPER
NOTE: THIS PROCEDURE REQUIRES TERMINAL TO BE POWERED UP.
STEP
ACTION
STEP
1
OPEN CONTROL PANEL. IF PAPER REMAINS ON
ROLL, CUT OR TEAR PAPER BETWEEN ROLL AND
PRINTER.
4
INSTALL NEW PAPER ROLL ONTO SPINDLE.
2
PRESS
5
INSERT PAPER/SPINDLE INTO PAPER BRACKET.
PAPER FEEDS FROM TOP OF ROLL!
6
FEED END OF PAPER INTO PRINTER TAKE-UP SLOT.
PAPER WILL FEED AUTOMATICALLY THROUGH
THE PRINTER AND SLIGHTLY OUT FRONT OF UNIT.
3
THE MANUAL FEED BUTTON TO CLEAR
REMAINING PAPER FROM FEED PATH.
REMOVE SPENT PAPER ROLL AND SPINDLE FROM
PAPER BRACKET.
6
ACTION
COMBINATION LOCKS
INTRODUCTION
THE SECURITY CABINET CAN BE SECURED USING EITHER A MECHANICAL OR ELECTRONIC COMBINATION LOCK. THIS PAGE COVERS
HOW TO OPERATE THE COMBINATION OF EITHER LOCK.
TO CHANGE COMBINATIONS, SEE ATTACHMENT TO THE USER MANUAL.
OPERATING THE MECHANICAL LOCK
UNLOCKING THE LOCK
THERE ARE TWO MARKS ON THE DIAL RING. THE INDEX AT THE TOP IS USED FOR OPENING THE LOCK, THE INDEX 30 DEGREES TO
THE LEFT IS USED ONLY WHEN CHANGING THE COMBINATION.
THE
DIAL SHOULD ALWAYS BE TURNED SLOWLY AND EVENLY.
A REVOLUTION IS COUNTED EACH TIME THE SELECTED NUMBER IS
DO NOT TURN THE DIAL BACK TO COMPENSATE FOR OVER-DIALING A NUMBER. IF, WHEN DIALING
THE COMBINATION, ANY NUMBER IS TURNED BEYOND THE INDEX, THE ENTIRE SEQUENCE MUST BE REPEATED.
ALIGNED WITH THE OPENING INDEX.
UNLOCKING 3-NUMBER COMBINATIONS (FOR EXAMPLE, “25-10-25”) SEE USER MANUAL FOR DEFAULT COMBINATION.
1.
TURN THE DIAL TO THE LEFT AT LEAST FOUR (4) COMPLETE TURNS TO CLEAR THE COMBINATION LOCK TO ACCEPT THE
COMBINATION.
2.
THE
USING THE ‘OPENING INDEX’, TURN THE DIAL TO THE LEFT, STOPPING WHEN ‘25’ IS ALIGNED WITH THE OPENING INDEX,
FOURTH TIME.
3.
TURN THE DIAL TO THE RIGHT, STOPPING WHEN ‘10’ IS ALIGNED WITH THE OPENING INDEX, THE THIRD TIME.
4.
TURN THE DIAL TO THE LEFT, STOPPING WHEN ‘25’ IS ALIGNED WITH THE OPENING INDEX, THE SECOND TIME.
5.
TURN THE DIAL SLOWLY TO THE RIGHT UNTIL THE BOLT RETRACTS.
OPERATING THE ELECTRONIC LOCK
THE ELECTRONIC LOCK COMBINATION CONSISTS OF SIX DIGITS. UPON ARRIVAL, THE COMBINATION OF THE LOCK SHOULD ALREADY
BE PRESET TO
1-2-3-4-5-6. NOTE: CHANGE THIS COMBINATION! SEE USER MANUAL FOR COMBINATION CHANGE PROCEDURES.
ENTERING THE COMBINATION
1.
ENTER THE CURRENT COMBINATION AND CHECK FOR PROPER OPERATION. AFTER EACH KEYPRESS, THE LOCK
AFTER THE FINAL DIGIT HAS BEEN ENTERED, THE LOCK WILL BEEP TWICE, AND THE OPEN PERIOD WILL BEGIN.
WILL BEEP.
2.
WHEN A VALID COMBINATION HAS BEEN ENTERED, THE OPERATOR WILL HAVE APPROXIMATELY 4 SECONDS TO OPEN THE LOCK.
3.
TO OPEN THE LOCK, TURN THE OUTER DIAL CLOCKWISE.
4.
AFTER THE LOCK IS OPENED, THE CABINET DOOR MAY BE OPENED.
LOCKOUT FEATURE
THE LOCK INCLUDES A ‘WRONG TRY PENALTY’ LOCKOUT FEATURE THAT PREVENTS ENTRY FROM UNAUTHORIZED PERSONNEL. THIS
FEATURE PERFORMS AS FOLLOWS:
LED FLASHES RED AT TEN (10) SECOND INTERVALS.
5-MINUTE DELAY.
7