Download DAI_MANL

Transcript
DAI User Manual
To receive data the application should call the DAIReadData function frequently. This function does two
jobs. Firstly it will return any received data from the session. Secondly it will do any actions necessary to
process the DARTS session. This second action is the same as the DAICmdStatus function , either or
both of which must be called frequently.
Once the application has finished with the session it need only close the port by calling DAIClosePort. If
necessary the Datataker can be set out of DARTS protocol mode when finished, or at any other time, by
calling DAISetMode.
One other utility function has not been described so far. The function DAINewBaudRate must be called
if the baud rate is changed during the course of a session. This is not very likely to be required but is
provided just in case.
Page 7
September 1992