Download Medana Operational&M..

Department: Technical Department
Machine preparation, start-up and Maintenance MANUAL
Document N°: 2144_2009_M_09_10
Author: M.Lambri
Page 70 of 82
Equipment Name: GK 72 Encapsulation Line
Equipment SN: GK72101005
Data: 06 Sep 2010
5.10 Oil roller
The Oil roller lubrication system needs to be cleaned if the ribbon lubrication is not uniform. This is carried
out in three stages:
 Tank cleaning
 Pump cleaning
 Special filter MTP
Tank cleaning
Remove the cover from the mygliol oil tank situated on the rear of machine.
Clean with water and Uppercut 50-50 solution, blow with compressed air and rinse with alcohol.
Tank filters cleaning
Check and clean the filters on the lubrication tank outlet
Pipeline cleaning
Disconnect the PVC tubes and blow compressed air (not higher than 3 bar) toward the oil roller.
Special filter MTP
Blow compressed air (not higher than 3 bar) toward the PVC tubes in the Special filter. Inject alcohol
through the PVC tubes in the Special filter MTP and blow with compressed air.
Oil Roller – Special filters MTP