Download SAMM 10
Transcript
MCDI S.A.M.M. Reference guide Page 7 INTRODUCTION COMPUTER DATE ERROR SAMM checks date differences from last observed date in Computer and displays a warning with option for operator to change System date. ***** WARNING ***** WARNING ***** SYSTEM DATE MISMATCH, VERIFY PLEASE YY/MM/DD As a safety measure, previous versions cause a lockup upon detecting a date difference. This new feature requires utmost attention from operator when this message is displayed. System date error may cause liabilities if security events are logged with wrong date. OUT OF DISK SPACE WARNING SAMM systematically checks the disk space available to receive and store data. When the level of availability is lower than one (1) megabyte, a warning is issued, every fifteen minute, to the operator. This tells him the emergency to clean up and create available working space. OPERATOR ID WARNING Every fifteen minute, a large display gives the actual operator number. This insures that the right person is operating the system and receiving the messages. BASIC CONFIGURATION The minimum configuration for SAMM is a 386 micro-processor with 4MB of RAM, a 40 Mb hard disk, one parallel port, 2 (two) serial ports and MS-DOS version 3.x or higher. INSTALLING SAMM To install SAMM, insert the diskette in slot A or B, close the door and enter the commands: A: <ENTER> (or B) INSTALL <ENTER> Should you install SAMM by copying all the files without using the installer, all files must be copied in a directory named SAMM and that directory must reside in the root directory of your hard drive. UPGRADING SAMM 8.1 TO 10.0 Use the above instruction ( INSTALL SAMM ) to install SAMM 10. Once it is done, from within your SAMM directory, type SAMM <ENTER> to verify that the installation was done properly. If SAMM runs properly, exit SAMM by pressing <F6>. To upgrade your existing files automatically, type MAJ8XA10 <ENTER> This operation will copy all your existing data and adapt your database to the new version. All existing informations of your previous version ( 8.1 ) will remain intact. Both version ( 8.1 and 10 ) can operate on the same system. Note : Modifications made while running one version will not affect the database of the other version. To upgrade version prior to 8.1, please contact your local dealer or our technical support group.