Download SAMM 10

Transcript
MCDI
S.A.M.M.
Reference guide
Page 7
INTRODUCTION
COMPUTER DATE ERROR
SAMM checks date differences from last observed date in Computer and displays a warning with option for
operator to change System date.
***** WARNING ***** WARNING *****
SYSTEM DATE MISMATCH, VERIFY PLEASE
YY/MM/DD
As a safety measure, previous versions cause a lockup upon detecting a date difference. This new feature
requires utmost attention from operator when this message is displayed. System date error may cause liabilities
if security events are logged with wrong date.
OUT OF DISK SPACE WARNING
SAMM systematically checks the disk space available to receive and store data. When the level of availability is
lower than one (1) megabyte, a warning is issued, every fifteen minute, to the operator. This tells him the
emergency to clean up and create available working space.
OPERATOR ID WARNING
Every fifteen minute, a large display gives the actual operator number. This insures that the right person is
operating the system and receiving the messages.
BASIC CONFIGURATION
The minimum configuration for SAMM is a 386 micro-processor with 4MB of RAM, a 40 Mb hard disk, one parallel
port, 2 (two) serial ports and MS-DOS version 3.x or higher.
INSTALLING SAMM
To install SAMM, insert the diskette in slot A or B, close the door and enter the commands:
A: <ENTER> (or B)
INSTALL <ENTER>
Should you install SAMM by copying all the files without using the installer, all files must be copied in a directory
named SAMM and that directory must reside in the root directory of your hard drive.
UPGRADING SAMM 8.1 TO 10.0
Use the above instruction ( INSTALL SAMM ) to install SAMM 10. Once it is done, from within your SAMM
directory, type SAMM <ENTER> to verify that the installation was done properly. If SAMM runs properly, exit
SAMM by pressing <F6>. To upgrade your existing files automatically, type MAJ8XA10 <ENTER>
This operation will copy all your existing data and adapt your database to the new version. All existing
informations of your previous version ( 8.1 ) will remain intact. Both version ( 8.1 and 10 ) can operate on the
same system.
Note : Modifications made while running one version will not affect the database of the other version.
To upgrade version prior to 8.1, please contact your local dealer or our technical support group.