Download warning - HIGH RENT

Transcript
Section 2 - Pre-Operation and Controls
Walk-Around Inspection
Begin your walk-around inspection at item 1. Continue to your
(counterclockwise when viewed from top) checking each item in sequence.
right
INSPECTION NOTE: On all components, make sure there are no loose or missing
parts, that they are securely fastened and no visible leaks or excessive wear exists
in addition to any other criteria mentioned. Inspect all structural members including
attachment for cracks, excessive corrosion and other damage.
1. Boom Sections & Lift, Tilt, Extend/Retract, Compensating (Slave) Cylinders • Check front, top, side & rear slider pads for adequate grease.
• Pivot pins secure; hydraulic hoses undamaged, not leaking.
2. Left Outrigger (12 & 13M)- Pins secure; hydraulic hoses & cylinder undamaged,
not leaking.
3. Front Work Lights - Clean, undamaged and work properly.
2-2
3121851