Download Sailing - Goodall Design

Rudder stock: housing of a rudder blade
Shackle: U-shaped metal strip with a pin to secure halyards etc
Shrouds (Side stay): Wire supporting the mast sideways
Spinnaker: Isometric sail hoisted when sailing downwind
Spinnaker pole: the pole between the hulls used to fly the spinnaker
Spreaders (Diamond): Metal struts placed in pairs to support the mast control the bend in the mast
Stamaster: Adjustable side stay connectors
Stern: Back of the boat
Tack: Forward lower corner of the sail
Tiller (extension): Steering stick connected to the tiller crossbar
Traveler (Car): Runs on the traveler track, which the main sheet is attached
Traveler (Track): Runs side to side on the rear beam
Transom: Flat vertical plane of the end of the hull
Trapeze: Wire to extend the body beyond the gunwale while sailing
Windward: The side of the boat opposite to where the sails are set to when sailing
Tools needed
Your C2 parts will come from the factory pre-rigged so that it can be assembled easily, quickly and
without an expensive tool kit, but be advised to have ready with you the following tools:
-
Sharp knife
Cross head screw driver - Philips #2
7 mm ring spanner
17 mm ring spanner or preferably a hexagonal socket
24 mm open spanner
Torque wrench (optional)
Shackle tool
Tape measure
Duralac sealant (anti corrosive paste)
Marine grease
Arrival of goods
A typical delivery would consist of 4 packages
-
2 Hull boxes
1 Gear box with sails, boom, foils, rudder stocks etc.
1 Beam box with main and rear beam
1 Mast box with mast and spinnaker pole
Platform
C2 Owner's Manual
8