Download M20TN
Transcript
MOONEY M20TN SECTION VII AIRPLANE AND SYSTEM DESCRIPTION 28. THROTTLE CONTROL Push throttle control forward to increase engine power. Pull throttle aft to decrease engine power. Vernier control is optional. 29. PROPELLER CONTROL Push propeller control forward to increase engine RPM; pull control aft to decrease engine RPM. Control is a vernier type and fine adjustments of RPM can be obtained by turning knob clockwise to increase RPM and counter clockwise to decrease RPM. Knob should not be turned IN any closer than .030” to .060” to panel nut face. 30. MIXTURE CONTROL Mixture control allows pilot to adjust the fuel--air ratio (mixture) of the engine. Push control forward to enrich mixture. Pull control full aft to close idle cut off, shutting down engine. Control is a vernier type and fine adjustments of mixture can be obtained by turning knob clockwise to enrich mixture and counterclockwise to lean. Knob should not be turned IN any closer than .030” to .060” to panel nut face. 31. WING FLAP SWITCH Flap switch, on console, operates the electrically-actuated wing flaps. The flap switch incorporates a pre-select feature for TAKEOFF and FULL DOWN positions. Move switch down to first detent position to obtain TAKE OFF flaps (10o). Move switch to full down position to select FULL DOWN flaps (33o). When flap switch is moved UP to either TAKEOFF position or FULL UP position the flaps will retract to the selected position. - CAUTION-- Positioning Flap Switch to the UP position retracts the flaps completely. 32. ALTERNATE STATIC SOURCE VALVE Pull alternate static source valve full aft to change source of static air for the altimeter, airspeed and vertical speed indicator from outside of aircraft to cabin interior. Air speed and altimeter readings are affected slightly when alternate static source is used (See Charts in SECTION V). 33. PARKING BRAKE CONTROL Depress brake pedals and pull parking brake control to set parking brake. Push parking brake control in to release parking brake. 34. CABIN VENT CONTROL (Fresh Air) Pull cabin vent control aft to open valve in mixing box connected to cabin air inlet vent located on the right side of the airplane. Optimum use of cabin vent control is described in the Cabin Environment Section. 35. CABIN HEAT CONTROL Pull cabin heat control to turn cabin heat on. To lower cabin temperature, cabin heat control is pushed forward toward the OFF position. Optimum use of cabin heat control is described in the Cabin Environment Section. 36. DEFROST CONTROL Pull defrost control to decrease air flow to lower cabin area and increase air flow to windshield ducts in the front of glareshield area. Optimum use of the defrost control is described in the Cabin Environment Section. ORIGINAL ISSUE -- 12--22--2006 AIRPLANE FLIGHT MANUAL 7 -- 11