Download User Manual

1. INSTALLATION
The following illustrations show a typical RV installation.
Removing the unit
If you are not sure how to install this unit correctly, please have it
installed by a qualified technician.
Before removing the unit, release the optional stay screw if fitted.
.
1
2
2
1
Disassembly
tool
Step
2
Step
1
Release
To remove the front panel:
.
1. Press the Panel Release Button.
2. After flipping the front panel down, push it to the right
( Step 1 ), then pull the left side out (Step 2 ).
Trim Plate
Sleeve
When you stand the unit, be careful
not to damage the fuse on the rear.
3
3
To re-attach the front panel back on to the unit chassis,
first insert the right mounting hole in to the right mounting
tab ( Step 1 ), then insert the left mount in to the left
tab ( Step 2 ).
Trim Plate
Insert the two disassembly
tools, then pull them as
illustrated so that the unit
can be removed.
Disassembly
tools
When using the optional stay
Step 2
Stay(option)
Step 1
18
2m
m
1
Screw
53
mm
Washer
Nut
Panel
2
Screw
(optional)
Screw
(4x12mm)
RV Panel
Sleeve
Sleeve
3
4
Trim
Plate
Bend the appropriate
tabs to hold the sleeve
firmly in place.
30°
Control
Panel
E-9
Install the unit at
an angle of less
than 30°.