Download Datacall manual - Datacall Telemetry

Transcript
2. Introduction
The Datacall Telemetry system uses 3G and GSM mobile phone networks to send alarm and status information to operator’s mobile phone and a web site. The Datacall Telemetry system consists of three components:
−
−
−
Datacall Gateway
Telecommunications Network
Datacall Server
The Datacall Gateway is the remote component of this system, it lets you monitor and interact to some degree with your remote field equipment by using SMS or the Internet. It is capable of accepting requests for the status of the unit, and values of its inputs and outputs. It will respond either via SMS or the web interface when it is requested or scheduled to do so.
The Datacall Gateway is compatible with most major 3G and GSM networks available worldwide. Both SMS and IP data features are utilised by the Datacall Telemetry system.
The user can interact with the unit by either SMS, the web site, or a web browser using the built in web server.
The Datacall Server is able to securely store all data from all units which you operate, and has a user friendly web interface. It has features such as charting of data, and a Gateway configuration and command interface. It allows you to monitor and control each of your devices, and allows for multiple users with multiple access levels.
The Datacall Gateway can be programmed to perform a specific application. Some of its features include a rostering system for alarms and scheduled commands. It has 8 digital inputs, four of which can be set as a counters for use on a pulse output metering sensor; it also has 4 analogue inputs and 4 digital outputs.
The Datacall Telemetry system can be as small as a single stand alone unit monitoring a single pump or as extensive as the whole country.
2