Download WOOD working MASTER

5. PRODUCE BORED TIMBER AND TIMBER-BASED PRODUCTS
KNOWLEDGE EVIDENCE
Paper A — Continued
Q5.
A high-speed router runs at very fast speeds. How would you determine
what type of lubricant you would use in the spindle bearings
A
Refer to manufacturer’s recommendations
B
Multigrade engine oil
C
Silicone spray
D
Grease
Q6.
If a load of H.D.F. is delivered swollen at the edges and warped, what would
the prodadle cause be?
A
They have been stacked incorrectly
B
They have been stored close to a source of heat
C
They have had direct contact with moisture
D
They have been damaged by the forklift
Q7.
A high-speed steel profile cutter is best suited for moulding soft wood. Is this
statement true or false?
A
True
B
False
Q8.
When edge moulding M.D.F. on the high-speed router, which type of cutter
would you select if the material was a stock item, and the job was repeated
frequently?
A
High speed steel
B
Tungston carbide tipped
C
Polycrystaline diamond
D
Carbon steel
Q9.
5.38
A pedestal drill has a variable speed due to:
A
frequency changer
B
stepped pulleys
C
gears
D
integral drive