Download You cannot Flash but only read this

Easergy T200, F200C, R200
IEC 60870-5-101
2. References
As mentioned above, the purpose of this appendix is to help the user set up a network. It is not intended to provide
a detailed explanation of the protocol specified in the documents referenced below. It is not necessary to read
these documents. However, the user faced with a specific problem or wanting to have a more precise knowledge of
this protocol will find it useful to read them. They are available, on a paying basis, on the IEC website (www.iec.ch).
The international standard used has been specified by the International Electrotechnical Commission in the
following documents:
•
IEC 60870-5-1:1990,
•
IEC 60870-5-2:1992,
•
IEC 60870-5-3:1992,
•
IEC 60870-5-4:1993,
•
IEC 60870-5-5:1993,
•
IEC 60870-5-101:2003,
Telecontrol equipment and systems – Part 5: Transmission protocols –
Section 1: Transmission frame formats
Telecontrol equipment and systems – Part 5: Transmission protocols – Section 2:
Link transmission procedures
Telecontrol equipment and systems – Part 5: Transmission protocols – Section 3:
General structure of application data
Telecontrol equipment and systems – Part 5: Transmission protocols – Section 4:
Definition and coding of application information elements
Telecontrol equipment and systems – Part 5: Transmission protocols – Section 5:
Basic application functions
Telecontrol equipment and systems – Part 5-101: Transmission protocols –
Companion standard for basic telecontrol tasks
These documents refer to other normative documents which can also be consulted. They are referenced as
follows:
•
•
IEC 60050(371):1984,
IEC 60870-1-1:1988,
•
IEC 60870-5-103:1997,
•
OSI/IEC 8824-1:2000,
•
ITU-T V.24:2000,
•
•
ITU-T V.28:1993,
ITU-T X.24:1988,
•
ITU-T X.27:1996,
•
IEEE 754:1985,
4
International Electrotechnical Vocabulary (IEV) – Chapter 371: Telecontrol
Telecontrol equipment and systems – Part 1: General considerations – Section 1:
General principles
Telecontrol equipment and systems – Part 5-103: Transmission protocols –
Companion standard for the informative interface of protection equipment
Information technology – Abstract Syntax Notation One (ASN.1): Specification of
basic notation
List of definitions for interchange circuits between data terminal equipment (DTE)
and data circuit-terminating equipment (DCE)s
Electrical characteristics for unbalanced double-current interchange circuits
List of definitions for interchange circuits between Data Terminal Equipment (DTE)
and Data Circuit-terminating Equipment (DCE) on public data networks
Electrical characteristics for balanced double-current interchange circuits operating
at data signalling rates up to 10 Mbit/s
Binary floating-point arithmetic
NT00156-EN-08