Download LC100 User Manual V7.5

LC100 Instruction manual
4/6 Parameters
D-32
4/12 Door
Passenger passing time after cabin call
Type D
0-25s
Passenger passing time after new cabin call while in station.
By giving new cabin command passenger passing time is set by parameter.
D-33
Door deceleration time
0-25s
Parameter is used to activate input function FO-42 (for A door) or FO-46 (for
B door) with doors with no before end-switches. Parameter estimates the time
of opening or closing the door and activates a low speed depending on the
parameter.
D-34
Door reversing time
0-2,5s
Parameter is time with no active commands for open and close door while
reversing.
D-35
Door resistors time
0-25s
The parameter is the time of the resistors to reduce the mechanical strain of
the door if resistor function is in use FO-43 for A-side door, FO-47 for B-side
door.
D-36
Door locking time
0-2,5s
After door lock acivating, system filtrates input for stabilizing door lock
contact and starts traveling after filter set by parameter. The parameter is used
to prevent safety circuit break after start command.
79