Download USER MANUAL

Lamp and Acrylic Replacement - 35
Lamp and Acrylic Replacement
Introduction
To be assured of maximum tanning effectiveness,
change lamps after approximately 500-700 hours
of use. Tanning will continue after this time but at
a slower rate. To ensure trouble-free operation of
your booth, replace the lamp starters whenever
the lamps are replaced.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
Opening/Replacing Acrylic Shields
Each acrylic shield is secured in place by four
quarter-turn latches. The Left Module is shown at
right. Using the acrylic key (included in the hardware kit) remove the floor. Then use it to unlock
the acrylic. 1Swing the acrylic open, 2lift it and
3pull the bottom out.
To replace the acrylic, insert the top hinge pin in
the hole at the top of the module, swing the bottom pin into place and drop it down to engage the
pin.
CAUTION
27342-01A
Be careful. The edges of the acrylic shield
may be sharp.