Download Elite Silent Extractor

Operating & Maintenance Manual
Shampoo Machines & Extractors
ATTENTION:
 The brush motor is protected from overload, by a protection located on the control panel. If this
protection kicks in and intervenes, you must reduce the pressure of the brush, to avoid overloading the
motor. If protection repeatedly intervenes, you should take your machine into a service agent. Repeated
interventions of this nature may result in faults which cannot be covered by warranty.
 When in operation keep a safe distance from other people and animals, who could be run over by the
machine. Pay attention to any object that could be hit by the machine. Never leave the machine
unguarded.
4) Lower the vacuum head by pushing on the rudder bar, which is situated on the right-lower
side of the machine.
To switch on the machine you must act on the switches on the control panel:
PUMP
II
O
O
O
I
I
I
VACUUM
BRUSH
CONTROL
LEVER
5) Set to position "I" the switches of the vacuum motor and the rotating brush.
6) Set to position "I" the pump switch. In the “I” setting the solution pump works only while the
control lever is pressed down. When the pump switch in position “II”, you will get a
continuous flow, without having to keep the spray laver pressed.
7) Set the regulation valve on the left-lower part of the machine, in order to regulate the
quantity of water sprayed on the carpet. Screw the knob to reduce the water-flow, and
unscrew it to increase the flow. To help prime the pump, unscrew the knob totally when
you first start your machine up.
For a routine maintenance cleaning of the carpet or floor turn on the switches for the vacuum
and pump and pull the lever on the wand handle to spray the solution. Slowly drag the tool
across the carpet/floor while pulling the trigger allowing the injection extraction to break down
dirt and suck up the waste water into the extractor.
ELITE-SILENT EXTRACTOR
6