Download User Manual - Projector Central

CONTENTS
Connections and installation
17
(Continued)
Connecting video equipment
Output terminals
Check that the power for the projector and computer is off before
connecting the cables.
(not supplied)
RS-232C
CONTROL
RGB
AUDIO
MONITOR OUTPUT
To CR(PR) output
To CB(PB) output
Audio cable (not supplied)
To Y output
To audio output R
(red)
To audio output L
(white)
To RGB
INPUT
(AUDIO)
Video player with color difference output
To RGB
INPUT
(RGB)
RGB
AUDIO
RGB INPUT
To VIDEO INPUT (VIDEO) (yellow)
VIDEO INPUT
S-VIDEO
To VIDEO
INPUT
(S-VIDEO)
VIDEO
Check that the power for the projector and computer is off before
connecting the cables.
RS-232C
CONTROL
RGB
AUDIO
MONITOR OUTPUT
To VIDEO INPUT (AUDIO R) (red)
Audio/Video cable (supplied)
To Video output (yellow)
AUDIO
RGB INPUT
VIDEO INPUT
S-VIDEO
VIDEO
L - AUDIO -R
You can connect an
extra monitor to view
the picture.
You can connect a computer
to control the projector. 49
L - AUDIO -R
To VIDEO INPUT (AUDIO L) (white)
RGB
To MONITOR OUTPUT (AUDIO)
Ø3.5mm STEREO mini plug
(Audio output level is constant.)
Audio cable
(not supplied)
To audio input
To Audio output (white)
S-VIDEO cable (not supplied)
To Audio output (red)
To S-VIDEO output
Connect a stereo system
for dynamic sound.
Video tape player
Note
Signal input to the S-VIDEO jack takes priority over that to the VIDEO
jack.
Notes
• Sound of the source which you select is output to the connected
stereo system, etc.
• The MONITOR OUTPUT (RGB output) connector always sends out a
signal which is input to the RGB INPUT (RGB input) connector
regardless of your source selection.
• Even while the projector is in standby mode, the MONITOR OUTPUT
(RGB output) connector continues its output.