Download - Z-Wave Products

Basic Functions . 36
Home > Basic Functions > Device Information and Settings > Z­Wave Properties > Settings > Saved Z­Wave Scenes > Network
Network
If you have more than one Z­Wave interface installed and they are not a part of the same network, then the Network
drop­down choice will be shown ­ most users will not see this on their screen. Use it to select the Z­Wave network that
you are configuring the saved scene to be used in. The network names are assigned at the Controller Management
page.
See also
Create a New Scene
Choose Scene / Rename To / Delete
Include HomeSeer
Edit Scene Devices
Save Changes / Save & Deploy Scene / Save & Test Deployed Scene
Home > Basic Functions > Device Information and Settings > Z­Wave Properties > Settings > Saved Z­Wave Scenes > Create a New Scene
Create a New Scene
Enter a name for your new scene here. The name should be descriptive, but it will be shown in drop­down lists so it is
best if it is not too long. If you wish to edit a scene you created earlier, do not enter anything in this box.
See also
Network
Choose Scene / Rename To / Delete
Include HomeSeer
Edit Scene Devices
Save Changes / Save & Deploy Scene / Save & Test Deployed Scene
Home > Basic Functions > Device Information and Settings > Z­Wave Properties > Settings > Saved Z­Wave Scenes > Choose Scene / Rename To / Delete
Choose Scene / Rename To / Delete
To make a change to a scene which was created earlier, choose that scene from the list of scene names in the drop­down
list. After choosing a scene, you can enter a new name for the scene in the "Rename To" box if you wish to change the
name. Also after choosing a scene, clicking on the red X at the end of the row will remove the scene from the system
(use with caution!) and the delete operation cannot be undone.
See also
Network
Create a New Scene
Include HomeSeer
Edit Scene Devices
Save Changes / Save & Deploy Scene / Save & Test Deployed Scene
Home > Basic Functions > Device Information and Settings > Z­Wave Properties > Settings > Saved Z­Wave Scenes > Include HomeSeer
Include HomeSeer
Unless the "No HomeSeer Associations" option is set on the controller management page, manual scenes on scene
controller buttons will automatically have your Z­Wave interface controller added to a scene so that the HomeSeer device
Z­Wave