Download IGD`278 USEFI`S MANUAL

MASTER
COMMANDGUIDE
Seclion 2
tOAD
protocoloptions(ff, /A),it is necessary
When usingrXON-XOFF
for the hostto either recognizeXON-XOFflor delays must be
inserted after each carriaqe return (end of each record).
Otherwise,every secondrecord may be lost.Also,if recognition of XOFF by the host computer is slow (more than two
characters),this problem could exist as well. In certain instances,a slower baud rate may help to correct the problem
(but is usually undesirable,due to extended download times,
especially with long files).
Spacing:A spaceis required before filenome;no spacesare
permitted where commasact as separators,
Commond Exomple
See SyntaxExample above.The first example showshow the
LOAD commandis used with ZICE (hostsoftwareutilizingsoftware protocol).If ZICE is used, /H becomesthe default,and
may therefore be omitted.With this example,a bias of '100His
added to the load address.
The second example loads a file from a host computer not
using ZICE software.For this application, the ICD's HOST/
AUX port must be connectedto a port on the hostcomputer
normally designated for a terminal (one having accessto the
OS commandlangnrage).
The messagreis sent to the host computer,followed by a carriagtereturn (specifiedby OD-which is itsASCII code)prompting the hostcomputerto transmitthe file TEST.HEXto the ICD.
The third exampleis used when the host computer'sOS command langmagecannot be accessed via the SIO port, but
rather from a separateterminal.This commandwill be given
to the ICD first, then the ICD will wait-ready to receive input
prompted from the hostterminal.
2-lo6 zAx
ICD-278for Z8O